MetalworkingFun Forum › Machining › Projects v
Big Steam Engine

Thread Modes
Big Steam Engine
doubleboost Offline
Super Moderator
******
Posts: 1,459
Threads: 159
Joined: Feb 2012
Location: Northern England
#7
07-29-2012, 02:55 PM
Hi
Lads
Not much progress to report
I was hoping to get the cylinder cast today
I painted the modified patern yesterday and the paint reacted (it looked like it had the pox)
Paint stripper and start again is the only way
[Image: IMG_3905.jpg]
[Image: IMG_3904.jpg]
[Image: IMG_3900.jpg]
[Image: IMG_3898.jpg]
[Image: IMG_3906.jpg]
John
http://www.youtube.com/user/doubleboost
Reply
Thanks given by:


Messages In This Thread
Big Steam Engine - by doubleboost - 07-22-2012, 04:12 PM
RE: Big Steam Engine - by krv3000 - 07-22-2012, 04:15 PM
RE: Big Steam Engine - by doubleboost - 07-22-2012, 04:19 PM
RE: Big Steam Engine - by DaveH - 07-22-2012, 04:29 PM
RE: Big Steam Engine - by krv3000 - 07-22-2012, 04:38 PM
RE: Big Steam Engine - by Mayhem - 07-23-2012, 05:53 AM
RE: Big Steam Engine - by doubleboost - 07-29-2012, 02:55 PM
RE: Big Steam Engine - by EdK - 07-29-2012, 04:58 PM
RE: Big Steam Engine - by doubleboost - 07-29-2012, 05:08 PM
RE: Big Steam Engine - by DaveH - 07-29-2012, 05:20 PM
RE: Big Steam Engine - by TomG - 07-31-2012, 07:04 AM
RE: Big Steam Engine - by doubleboost - 07-31-2012, 02:47 PM
RE: Big Steam Engine - by nel2lar - 08-05-2012, 06:45 PM
RE: Big Steam Engine - by doubleboost - 08-06-2012, 02:54 PM



Users browsing this thread: 2 Guest(s)