|
engine No 11
|
03-04-2012, 09:54 AM
HI all right the fly wheel is basacley mad up of two peses a stanles steel rim and a brass center the rim was hand cut fron a pece of stanles steel then the the center was chane drilld to remove the bulke of it then drest to sise in the lathe the brass center was marked out then drilld to ruff cut out the webs then hand filed then silver solderd up mor pics
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
engine No 11 - by krv3000 - 02-28-2012, 07:28 AM
RE: engine No 11 - by Mayhem - 02-28-2012, 07:44 AM
RE: engine No 11 - by DaveH - 02-28-2012, 08:10 AM
RE: engine No 11 - by krv3000 - 02-28-2012, 08:25 AM
RE: engine No 11 - by krv3000 - 02-28-2012, 08:33 AM
RE: engine No 11 - by ETC57 - 02-28-2012, 12:19 PM
RE: engine No 11 - by krv3000 - 02-28-2012, 05:27 PM
RE: engine No 11 - by DaveH - 03-04-2012, 08:30 AM
RE: engine No 11 - by krv3000 - 03-04-2012, 09:54 AM
RE: engine No 11 - by DaveH - 03-06-2012, 07:38 PM
RE: engine No 11 - by krv3000 - 03-09-2012, 05:26 PM
RE: engine No 11 - by doubleboost - 03-09-2012, 05:42 PM
RE: engine No 11 - by DaveH - 03-09-2012, 05:51 PM
RE: engine No 11 - by EdK - 03-09-2012, 06:13 PM
RE: engine No 11 - by krv3000 - 03-10-2012, 04:10 PM
|
