Arbor for mill advice
#3
PixMan,
I do not know what sizes I will be making yet, but with my luck they will be all different. I was just trying to get something that would fit a least a few different sizes. Arbors are easy to make, but would not like to have a lot around that maybe just gets used once. Most I think will be 6" or less, but I do have to make 2 that have the teeth facing inward and about 7" dia. inside and this would not work with a arbor and will have to be milled. My 4 jaw chuck is about 2 1/2" dia. and I could make it close to the chuck if it is bigger than that and maybe not use a tail stock if the material is soft like alum. or brass. I am just trying to think of a better way to do them. When I get one to make it will be a rush to get them done for a store near me because to send away for them takes too long for them and the machine will be down and that is money.
Paul
pjf134, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:


Messages In This Thread
Arbor for mill advice - by pjf134 - 03-03-2012, 11:09 PM
RE: Arbor for mill advice - by PixMan - 03-03-2012, 11:39 PM
RE: Arbor for mill advice - by pjf134 - 03-04-2012, 12:38 AM
RE: Arbor for mill advice - by TOM REED - 03-04-2012, 01:32 AM
RE: Arbor for mill advice - by Wongster - 03-27-2012, 11:20 AM



Users browsing this thread: 2 Guest(s)