Arbor for mill advice
#2
You might consider making one "master arbor" that has a shoulder on it and perhaps a keyway, then make mating sleeves to fit the gear blanks as they come along. The issues with that would be in determining the best diameter and length to make it.

What size gears will you be making, in terms of O.D. and I.D.? If you have a lathe it's probably an easy task to make up arbors as you go along, as there's nothing particularly complicated about them.
Reply
Thanks given by:


Messages In This Thread
Arbor for mill advice - by pjf134 - 03-03-2012, 11:09 PM
RE: Arbor for mill advice - by PixMan - 03-03-2012, 11:39 PM
RE: Arbor for mill advice - by pjf134 - 03-04-2012, 12:38 AM
RE: Arbor for mill advice - by TOM REED - 03-04-2012, 01:32 AM
RE: Arbor for mill advice - by Wongster - 03-27-2012, 11:20 AM



Users browsing this thread: 1 Guest(s)