07-27-2012, 01:20 PM
(07-27-2012, 09:04 AM)Wongster Wrote: Thanks Greg. I'll have a look. Maybe the locking screw work loose after changing tools a few times. If that's the case, do you think its a good idea to put a drop of loctite on the QC holder to hold the position of the locking screw? If I've to check every time, my QCTP will have to be renamed to SCTP (slow change tool post)...I end up with chips hiding in the dovetail where the post sits on the compound slide which will hold the next holder up high when you change tools,
Regards,
Wong
you might want to check and see if thats whats happening, only take a small chip to push the holder up a good ways.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!