MetalworkingFun Forum › Machining › Projects v
Hexy ER 32 Collet Holder

Thread Modes
Hexy ER 32 Collet Holder
doubleboost Offline
Super Moderator
******
Posts: 1,459
Threads: 159
Joined: Feb 2012
Location: Northern England
#3
03-03-2012, 05:53 PM
(03-03-2012, 05:48 PM)DaveH Wrote: Hi John,

So far so good Smiley-signs107

A nice bit of chamfering, what is the hole for?

Smiley-eatdrink004
DaveH

Hi
Dave
The hole is there in case i need to machine a hex on the end of a long bar SmileSmileSmileSmile
I bored it half way then broke in to it from the nose endBig GrinBig GrinBig Grin
John
http://www.youtube.com/user/doubleboost
Reply
Thanks given by:


Messages In This Thread
Hexy ER 32 Collet Holder - by doubleboost - 03-03-2012, 05:31 PM
RE: Hexy ER 32 Collet Holder - by DaveH - 03-03-2012, 05:48 PM
RE: Hexy ER 32 Collet Holder - by doubleboost - 03-03-2012, 05:53 PM
RE: Hexy ER 32 Collet Holder - by DaveH - 03-03-2012, 05:58 PM
RE: Hexy ER 32 Collet Holder - by doubleboost - 03-04-2012, 04:23 PM
RE: Hexy ER 32 Collet Holder - by DaveH - 03-04-2012, 04:31 PM
RE: Hexy ER 32 Collet Holder - by ETC57 - 03-04-2012, 06:06 PM
RE: Hexy ER 32 Collet Holder - by doubleboost - 03-04-2012, 06:15 PM
RE: Hexy ER 32 Collet Holder - by ETC57 - 03-04-2012, 06:31 PM
RE: Hexy ER 32 Collet Holder - by EdK - 03-04-2012, 07:29 PM
RE: Hexy ER 32 Collet Holder - by miner49r - 03-05-2012, 12:38 AM
RE: Hexy ER 32 Collet Holder - by Mayhem - 06-29-2012, 08:59 PM
RE: Hexy ER 32 Collet Holder - by krv3000 - 06-30-2012, 02:08 PM
RE: Hexy ER 32 Collet Holder - by LIRF - 11-09-2013, 03:45 PM



Users browsing this thread: 1 Guest(s)