07-25-2012, 11:28 AM
Tom,
To make sure I understand what you wrote. You mean to thread the rod and drill & tap the hole in the middle? If that's the case, should I use a screw with the head cut off instead if threading the rod?
Regards,
Wong
To make sure I understand what you wrote. You mean to thread the rod and drill & tap the hole in the middle? If that's the case, should I use a screw with the head cut off instead if threading the rod?
Regards,
Wong
Wongster
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.
http://www.wongstersproduction.com
Proud to be a member of MetalworkingFun Forum since Mar 2012.