MetalworkingFun Forum › Machining › General Metalworking Discussion v
Rotary Table

Thread Modes
Rotary Table
knapper
Unregistered
 
#7
07-22-2012, 01:39 PM
Dave H.

Thank you very much. Even though the directions fit a 4 inch Table.. I will be able to correct it so it will
apply to my 6 inch Table..

Now to sit down and study this very carefully.. Do I dare ask what a set of those dividing plates cost???

Knapper
Reply
Thanks given by:


Messages In This Thread
Rotary Table - by knapper - 07-22-2012, 12:48 AM
RE: Rotary Table - by DaveH - 07-22-2012, 06:31 AM
RE: Rotary Table - by knapper - 07-22-2012, 10:05 AM
RE: Rotary Table - by ETC57 - 07-22-2012, 03:55 PM
RE: Rotary Table - by dallen - 07-25-2012, 09:58 AM
RE: Rotary Table - by DaveH - 07-22-2012, 10:32 AM
RE: Rotary Table - by knapper - 07-22-2012, 10:53 AM
RE: Rotary Table - by DaveH - 07-22-2012, 12:14 PM
RE: Rotary Table - by knapper - 07-22-2012, 01:39 PM
RE: Rotary Table - by EdK - 07-22-2012, 01:52 PM
RE: Rotary Table - by ETC57 - 07-26-2012, 01:15 PM



Users browsing this thread: 2 Guest(s)