07-22-2012, 08:43 AM
Morning Rick
did a little work on the Mini Mill last night but was having trouble seeing the high spots down in the vee on the Column Saddle Block that I have been working on.
No need for a sketch of the 3 Corner scrapper I have a couple of the store bought variety. I do need to make one that is only about a 1/4" wide for working down in the Vees of the mini mill just not any room in there, and GET a light that I can see with (really need the glasses I left in Tulsa)
The two half inch wide scrapers that I already made pretty much follow your design except it width and the taper on the end I did try to thin the carbide down but it was only so I could see over the end of the tool better, and so that I wouldn't have so much to hone.
did a little work on the Mini Mill last night but was having trouble seeing the high spots down in the vee on the Column Saddle Block that I have been working on.
No need for a sketch of the 3 Corner scrapper I have a couple of the store bought variety. I do need to make one that is only about a 1/4" wide for working down in the Vees of the mini mill just not any room in there, and GET a light that I can see with (really need the glasses I left in Tulsa)
The two half inch wide scrapers that I already made pretty much follow your design except it width and the taper on the end I did try to thin the carbide down but it was only so I could see over the end of the tool better, and so that I wouldn't have so much to hone.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!