|
Big Lathe Faceplate Project
|
07-21-2012, 08:52 PM
(03-26-2012, 05:51 PM)aametalmaster Wrote: Heres another pic i found. Cutting the backside from the frontside. I don't do too much textbook machining i have to wing a lot of it...Bob I like to call it contrary machining. It doesn't always need to be done by the book. Nice job on the faceplate Bob. What are you going to do with the other blanks? Tom ![[Image: TomsTechLogo-Profile.png]](http://tomstechniques.com/wp-content/uploads/2013/11/TomsTechLogo-Profile.png) |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Big Lathe Faceplate Project - by aametalmaster - 03-26-2012, 05:31 PM
RE: Big Lathe Faceplate Project - by aametalmaster - 03-26-2012, 05:33 PM
RE: Big Lathe Faceplate Project - by EdK - 03-26-2012, 05:54 PM
RE: Big Lathe Faceplate Project - by aametalmaster - 03-26-2012, 05:51 PM
RE: Big Lathe Faceplate Project - by dallen - 07-20-2012, 03:39 PM
RE: Big Lathe Faceplate Project - by TomG - 07-21-2012, 08:52 PM
RE: Big Lathe Faceplate Project - by DaveH - 03-26-2012, 08:28 PM
RE: Big Lathe Faceplate Project - by Mayhem - 03-26-2012, 11:42 PM
RE: Big Lathe Faceplate Project - by doubleboost - 07-20-2012, 02:53 PM
RE: Big Lathe Faceplate Project - by krv3000 - 07-21-2012, 02:54 PM
RE: Big Lathe Faceplate Project - by Bill Gruby - 07-21-2012, 03:07 PM
RE: Big Lathe Faceplate Project - by EdK - 07-21-2012, 03:30 PM
|
