07-20-2012, 07:23 AM
Rick
The two scrapers that I made all I did for sharpening them was to slightly round the end of the carbide and put some bevel onto the top with a bench grinder, then I have found that the straight one cuts better all across the edge if I hold it vertical and run a diamond hone straight across the edge at a 90 degree angle.
The two scrapers that I made all I did for sharpening them was to slightly round the end of the carbide and put some bevel onto the top with a bench grinder, then I have found that the straight one cuts better all across the edge if I hold it vertical and run a diamond hone straight across the edge at a 90 degree angle.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!