Holding Tools in MT2 spindle without drawbar

Thread Modes

Holding Tools in MT2 spindle without drawbar

dallen Offline

Senior

Posts: 1,827
Threads: 51
Joined: Apr 2012
Location: Oklahoma

07-14-2012, 09:20 PM

I would make a new on with a straight shank for use in your new mill using a collet to hold it with.

dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue

« Next Oldest | Next Newest »

Messages In This Thread

RE: Holding Tools in MT2 spindle without drawbar - by dallen - 07-14-2012, 09:20 PM

Users browsing this thread: 1 Guest(s)