07-14-2012, 09:11 PM
heres a photo of the gib that goes in the slide that I have been working on, I didn't think to take a photo before I started working on the gib. The gib was only touching on the very ends when I started.
I still have a little bit of scrapping left to totally remove the big scratch that is/was down the middle of the gib.
One thing I will say is that any one attempting to do this is to get a piece of wood and cut a dovetail slot in it either in a mill or with a router. I would not of been able to of done the work on the gib that I did without the board that I fixed. I have to thank Kanal von MuellerNick while watching one of his videos on scrapping he showed the setup that he uses for gibs.
Enough rambling to the photos.
I still have a little bit of scrapping left to totally remove the big scratch that is/was down the middle of the gib.
One thing I will say is that any one attempting to do this is to get a piece of wood and cut a dovetail slot in it either in a mill or with a router. I would not of been able to of done the work on the gib that I did without the board that I fixed. I have to thank Kanal von MuellerNick while watching one of his videos on scrapping he showed the setup that he uses for gibs.
Enough rambling to the photos.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!