07-14-2012, 08:36 PM
Just my opinion, which is far from an expert one, but i'd be concerned using a fly cutter like that without a draw bar.
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
MetalworkingFun Forum
›
Machining
›
General Metalworking Discussion
Holding Tools in MT2 spindle without drawbar
Holding Tools in MT2 spindle without drawbar
|
Holding Tools in MT2 spindle without drawbar
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Holding Tools in MT2 spindle without drawbar - by Wongster - 07-14-2012, 08:08 PM
RE: Holding Tools in MT2 spindle without drawbar - by sasquatch - 07-14-2012, 08:36 PM
RE: Holding Tools in MT2 spindle without drawbar - by dallen - 07-14-2012, 09:20 PM
RE: Holding Tools in MT2 spindle without drawbar - by EdK - 07-14-2012, 09:59 PM
RE: Holding Tools in MT2 spindle without drawbar - by Wongster - 07-14-2012, 10:27 PM
RE: Holding Tools in MT2 spindle without drawbar - by DaveH - 07-15-2012, 06:24 AM
RE: Holding Tools in MT2 spindle without drawbar - by Wongster - 07-15-2012, 06:49 AM
|
Users browsing this thread: 1 Guest(s)