|
engine No 11
|
02-28-2012, 08:25 AM
HI well all my engines are made from scrap no castings I don't have a mill so a lt of the work is by hand this engen is my a temt at copeing a stuart turner horisontel No10 righ the cilender is made out of steel with the bace of the valve chest silver solderd to it it had a 16MM bore and 45MM stroke sum pics
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
engine No 11 - by krv3000 - 02-28-2012, 07:28 AM
RE: engine No 11 - by Mayhem - 02-28-2012, 07:44 AM
RE: engine No 11 - by DaveH - 02-28-2012, 08:10 AM
RE: engine No 11 - by krv3000 - 02-28-2012, 08:25 AM
RE: engine No 11 - by krv3000 - 02-28-2012, 08:33 AM
RE: engine No 11 - by ETC57 - 02-28-2012, 12:19 PM
RE: engine No 11 - by krv3000 - 02-28-2012, 05:27 PM
RE: engine No 11 - by DaveH - 03-04-2012, 08:30 AM
RE: engine No 11 - by krv3000 - 03-04-2012, 09:54 AM
RE: engine No 11 - by DaveH - 03-06-2012, 07:38 PM
RE: engine No 11 - by krv3000 - 03-09-2012, 05:26 PM
RE: engine No 11 - by doubleboost - 03-09-2012, 05:42 PM
RE: engine No 11 - by DaveH - 03-09-2012, 05:51 PM
RE: engine No 11 - by EdK - 03-09-2012, 06:13 PM
RE: engine No 11 - by krv3000 - 03-10-2012, 04:10 PM
|
