A fix for bad fitting splines in Chinese mills

Hello There, Guest! Register

Thread Modes

A fix for bad fitting splines in Chinese mills

bert59
Unregistered

#7

07-13-2012, 12:20 PM

I have the same problem after one hour use with CNC 2000rpm it starts rateling Confused

Confused

The bearings are getting warm then and go easier.
And the rateling starts Chin

Chin

I bought a new gear with spline and a new spindle
The problem is not solved Bash

Bash

Bash

Bash

Bash

Bash

Bash

Reply

« Next Oldest | Next Newest »

Messages In This Thread

A fix for bad fitting splines in Chinese mills - by Dave J - 05-10-2012, 10:33 AM

RE: A fix for bad fitting splines in Chinese mills - by DaveH - 05-10-2012, 04:19 PM

RE: A fix for bad fitting splines in Chinese mills - by EdK - 05-10-2012, 04:40 PM

RE: A fix for bad fitting splines in Chinese mills - by EdK - 05-11-2012, 12:17 PM

RE: A fix for bad fitting splines in Chinese mills - by Dave J - 05-11-2012, 07:29 PM

RE: A fix for bad fitting splines in Chinese mills - by EdK - 05-12-2012, 08:50 AM

RE: A fix for bad fitting splines in Chinese mills - by bert59 - 07-13-2012, 12:20 PM

RE: A fix for bad fitting splines in Chinese mills - by EdK - 07-13-2012, 03:36 PM

RE: A fix for bad fitting splines in Chinese mills - by bert59 - 07-13-2012, 03:46 PM

RE: A fix for bad fitting splines in Chinese mills - by DanH - 12-23-2012, 12:29 PM

RE: A fix for bad fitting splines in Chinese mills - by Dave J - 12-24-2012, 01:32 AM

Users browsing this thread: 1 Guest(s)