07-13-2012, 07:51 AM
woke up on the early side this morning and decided that I would just mill the part that I had questions about. So I clamped it up and took off about 3 thousands just enough that it all the surface had seen the cutter. Then I measured it just like I did last night and was it ever close, but in my wisdom I said that it could be better.
So I marked up the surface plate and proceeded to work on it some. heres the photos.
So I marked up the surface plate and proceeded to work on it some. heres the photos.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!