mini mill

[dallen]

(07-12-2012, 06:23 PM)ETC57 Wrote: Question?

Is there a thread here somewhere on scraping?
I'm not sure I understand the concept.

Jerry.

hand scraping is the way the old timers used to fit things together, the machinist would make the parts and the fitters would scrap things into spec.

or if you wanted a straight edge you made three of them and you scrapped them so that all three would fit together, you can't get them any straighter than that.

here is a link that I think is about the best on scrapping the guy has a bunch of videos

http://www.youtube.com/watch?v=uHF7TtHVS...9&index=19