Silver soldering BS blades or Carbide?

[TomG]

(07-12-2012, 03:54 PM)stevec Wrote: Thanks for the response guys, I've often brazed bandsaw blades on my homemade jig but I've not had success putting a rod to a carbide bit without disturbing the lttle carbide piece. Maybe I need to make a jig to hold the carbide? I just thought that slipping a piece of that "ribbon" under would work.

Maybe a block with a slot and set screws to hold the shank and a small toggle clamp to hold the carbide in place? Just thinking out loud.