07-12-2012, 08:22 AM
Pic #1 mounting flange cut. Pic#2 yea, it fits tight. Pic#3 all three parts. Pic #4 they fit tight. Pic #5, mounted to the Turbo Case, again nice and tight.
Today will be taken up by drilling and tapping all the holes that hold these four units together. Then the finish OD on the crankcase can be dealt with.
Thanks for all the encouragement. This is a slow moving project and it's about to get slower.
"Billy G"
Today will be taken up by drilling and tapping all the holes that hold these four units together. Then the finish OD on the crankcase can be dealt with.
Thanks for all the encouragement. This is a slow moving project and it's about to get slower.
"Billy G"