Just so Ed does not feel bad about posting 3D prints ...
The problem statement:
The hand cleaner dispenser is in a convenient spot to use, mounted on the lid of the ubiquitous HF 5 drawer cart. But if it leaks or drips the goo goes into the stuff below, hence the paper towel. There must be a better way.
Some measurements and then quality time with TinkerCAD ends up with something like this ...
And when mounted, it gives the impression it was meant to be there in the first place
Now I can also feel bad about posting 3D prints.
The problem statement:
The hand cleaner dispenser is in a convenient spot to use, mounted on the lid of the ubiquitous HF 5 drawer cart. But if it leaks or drips the goo goes into the stuff below, hence the paper towel. There must be a better way.
Some measurements and then quality time with TinkerCAD ends up with something like this ...
And when mounted, it gives the impression it was meant to be there in the first place
Now I can also feel bad about posting 3D prints.