10-04-2024, 12:23 PM
I ordered one of these adapters from a company that had them listed as IN STOCK and they charged my credit card. A week later they said they don't have any.... 
I am looking for ideas on how I can reproduce the center portion of this adapter (now out of production) using off the shelf fittings / plugs etc. The nipples fit 3/16" ID tubing. All the adapter does is sit over the sensor of my meter using a foam / rubber washer to seal it at the bottom. Gas flows into one nipple on top down to the sensor, and any excess gas is vented out through the other (open) nipple. So somehow I have to make one.
snifit_cal.jpg (Size: 24.13 KB / Downloads: 44)
I am looking for ideas on how I can reproduce the center portion of this adapter (now out of production) using off the shelf fittings / plugs etc. The nipples fit 3/16" ID tubing. All the adapter does is sit over the sensor of my meter using a foam / rubber washer to seal it at the bottom. Gas flows into one nipple on top down to the sensor, and any excess gas is vented out through the other (open) nipple. So somehow I have to make one.
snifit_cal.jpg (Size: 24.13 KB / Downloads: 44)
Willie