|
Base plate.
|
|
09-18-2024, 03:28 PM
(09-18-2024, 12:24 PM)EdK Wrote: Here's a quick first pass at it. Good grief! Do you have a mind meld with your CAD program?  That looks like the hot ticket with maybe one fly in the ointment. The pins on the DIP switches are only 1 - 2mm away from the side edges of the board. It may need a couple of relief "cuts" on the side walls of the base?  I can understand wanting to save money on the size of the board they use, but REALLY?
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Base plate. - by Highpower - 09-18-2024, 02:13 AM
RE: Base plate. - by EdK - 09-18-2024, 09:02 AM
RE: Base plate. - by Highpower - 09-18-2024, 12:14 PM
RE: Base plate. - by EdK - 09-18-2024, 12:24 PM
RE: Base plate. - by Highpower - 09-18-2024, 03:28 PM
RE: Base plate. - by EdK - 09-18-2024, 06:24 PM
RE: Base plate. - by rleete - 09-18-2024, 02:56 PM
RE: Base plate. - by Highpower - 09-18-2024, 03:19 PM
RE: Base plate. - by EdK - 09-27-2024, 10:39 AM
RE: Base plate. - by Highpower - 09-27-2024, 01:12 PM
RE: Base plate. - by EdK - 09-27-2024, 02:08 PM
RE: Base plate. - by Highpower - 09-27-2024, 04:15 PM
RE: Base plate. - by rleete - 09-27-2024, 12:05 PM
RE: Base plate. - by EdK - 09-27-2024, 12:17 PM
RE: Base plate. - by Highpower - 09-27-2024, 01:08 PM
RE: Base plate. - by EdK - 09-27-2024, 11:05 PM
RE: Base plate. - by rubes - 09-28-2024, 09:49 AM
RE: Base plate. - by Highpower - 09-28-2024, 03:30 PM
RE: Base plate. - by Highpower - 10-03-2024, 08:24 PM
|
