09-18-2024, 09:02 AM
(09-18-2024, 02:13 AM)Highpower Wrote: Hey Ed...
I wanted to ask if I can commission you again for another part. I finally got the capacitor board I've been waiting on and had plans to put it into a DIN rail housing that I have for another board. Of course the new board is too small and isn't going to fit. And with the DIP switches mounted right at the edges of the board it wouldn't be able to slide into the grooves of the housing anyway.
Wondering if you could print a simple base plate/frame for the board to sit on that has about an 8mm deep recess in it for clearance under the board for the banana jacks and leads sticking out the bottom?
Sure, not a problem. I'll be back to Arizona on the 25th so I can whip it up once I get back.
Ed