[PROJECT] Mini Lathe Mods

[EdK]

(08-25-2024, 05:31 PM)Highpower Wrote:

(08-25-2024, 04:46 PM)EdK Wrote: Got back to it and did a few more experiments and finally concluded that the lead screw had to be bent so I set it up in the the mill vise with a v-block and I could clearly see the end wobbling. I put a dial indicator on the end and this is what I got.  

A new leadscrew is on its way.  

Ed

 

Got arbor press?  

I thought about that but I do not have a press of any sort. Besides, it shouldn't have been bent in the first place. I bought if from LMS so no issues getting it replaced.

Ed