08-16-2024, 12:14 PM
First off, yea or nay?
If yea, did you buy or make? What material?
Grizzly sells them for my mill, but they have holes for coolant, which kinda defeats the purpose for me. I've found others on-line, but apparently my size is unusual enough that they aren't readily available.
Ed, have you got 3D printed ones on your machine?
BTW, my mill specs say the slots are 12mm, but they are much closer to 7/16", or just a hair over 11mm.
If yea, did you buy or make? What material?
Grizzly sells them for my mill, but they have holes for coolant, which kinda defeats the purpose for me. I've found others on-line, but apparently my size is unusual enough that they aren't readily available.
Ed, have you got 3D printed ones on your machine?
BTW, my mill specs say the slots are 12mm, but they are much closer to 7/16", or just a hair over 11mm.
Full of ideas, but slow to produce parts