07-30-2024, 03:53 PM
Okay, never mind this.
I just measured the stack up. Using this adapter puts the face of the 3-jaw over 7.5 inches from the face of the spindle. So, hanging more than 8" from the headstock, and using up more than half of the bed. I'm guessing that's a pretty bad idea.
Damn. I wish there was a simple cam lock setup for mini lathes.
I just measured the stack up. Using this adapter puts the face of the 3-jaw over 7.5 inches from the face of the spindle. So, hanging more than 8" from the headstock, and using up more than half of the bed. I'm guessing that's a pretty bad idea.
Damn. I wish there was a simple cam lock setup for mini lathes.
Full of ideas, but slow to produce parts