MetalworkingFun Forum › Machinery › Lathes v
[PROJECT] Mini Lathe Mods

Thread Modes
Project Mini Lathe Mods
Highpower Offline
JAFO
******
Posts: 4,375
Threads: 178
Joined: Feb 2012
Location: Missouri, USA
The following 1 user Likes Highpower's post:
EdK (06-04-2024)
#10
06-03-2024, 03:46 PM
(06-02-2024, 08:50 PM)EdK Wrote: ... I had bought the disk from McMaster and it was advertised as being 1/2" thick but it was 5/8". I guess that's better than being narrower than advertised.

Ed

Better to be looking at it than looking FOR it as Keith Fenner would say.
Willie
Reply
Thanks given by:


Messages In This Thread
Mini Lathe Mods - by EdK - 05-27-2024, 02:43 PM
RE: Mini Lathe Mods - by JScott - 05-27-2024, 04:01 PM
RE: Mini Lathe Mods - by EdK - 05-27-2024, 04:20 PM
RE: Mini Lathe Mods - by rleete - 05-27-2024, 06:36 PM
RE: Mini Lathe Mods - by EdK - 05-27-2024, 06:41 PM
RE: Mini Lathe Mods - by EdK - 06-01-2024, 05:23 PM
RE: Mini Lathe Mods - by EdK - 06-02-2024, 08:50 PM
RE: Mini Lathe Mods - by Highpower - 06-03-2024, 03:46 PM
RE: Mini Lathe Mods - by rleete - 06-03-2024, 09:10 AM
RE: Mini Lathe Mods - by EdK - 06-03-2024, 11:27 AM
RE: Mini Lathe Mods - by EdK - 06-04-2024, 12:46 AM
RE: Mini Lathe Mods - by EdK - 06-04-2024, 02:06 PM
RE: Mini Lathe Mods - by rleete - 06-04-2024, 03:11 PM
RE: Mini Lathe Mods - by EdK - 06-04-2024, 04:42 PM
RE: Mini Lathe Mods - by EdK - 06-04-2024, 04:45 PM
RE: Mini Lathe Mods - by rleete - 06-04-2024, 04:56 PM
RE: Mini Lathe Mods - by EdK - 06-04-2024, 06:04 PM
RE: Mini Lathe Mods - by rleete - 06-05-2024, 09:48 AM
RE: Mini Lathe Mods - by EdK - 06-05-2024, 12:36 PM
RE: Mini Lathe Mods - by EdK - 06-11-2024, 12:21 PM
RE: Mini Lathe Mods - by rleete - 06-20-2024, 06:37 AM
RE: Mini Lathe Mods - by EdK - 06-20-2024, 11:45 AM



Users browsing this thread: 4 Guest(s)