05-20-2024, 02:56 PM
Just got this delivered:
I have a very small part that I need to duplicate, and I needed a way to hold it while cutting the profile. Nothing I had would quite do the trick. Less than $9, and I was quite surprised at the quality of it. Finish is perfect, handle is tight and the clamp screw turns smoothly. So far it has done what I expected, and hopefully keeps my fingers from contacting the cutting surfaces.
I have a very small part that I need to duplicate, and I needed a way to hold it while cutting the profile. Nothing I had would quite do the trick. Less than $9, and I was quite surprised at the quality of it. Finish is perfect, handle is tight and the clamp screw turns smoothly. So far it has done what I expected, and hopefully keeps my fingers from contacting the cutting surfaces.
Full of ideas, but slow to produce parts