|
General question on tooling
|
05-08-2024, 06:21 AM
My favorite, and most used tool, is my Starrett dial caliper. As to machine tooling, I'd have to say my hand ground HSS lathe tool bits. I took my time to grind them to get the angles just right, and I know they do about 80% of the turning I do.
Full of ideas, but slow to produce parts
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
General question on tooling - by JScott - 05-07-2024, 06:44 PM
RE: General question on tooling - by rubes - 05-07-2024, 08:33 PM
RE: General question on tooling - by EdK - 05-08-2024, 01:19 AM
RE: General question on tooling - by rleete - 05-08-2024, 06:21 AM
RE: General question on tooling - by JScott - 05-08-2024, 10:18 AM
RE: General question on tooling - by EdK - 05-08-2024, 11:25 AM
RE: General question on tooling - by JScott - 05-08-2024, 06:31 PM
|
