(03-16-2024, 02:51 AM)EdK Wrote:(03-15-2024, 09:29 PM)Dr Stan Wrote: I've found plenty of spindle nose dimensions for the face, but none of the side view. Can anyone help me out?
Is this what you're looking for?
D1 Spindle Specs
Ed
I've seen that one before. It has the specs for the end of the spindle nose, but not the ones for the locking pin holes that are at 90 degrees to the center line. Those are the ones I need. These are for the pins one turns to about 90 degrees when locking the work holding device to the spindle nose. I can fairly well guess at them but, I'm adverse to doing so as I'll be using a nice piece of 4340, 6" dia and 2.5" long.Not the easiest thing to locate here in the PI.