07-08-2012, 09:57 PM
ok, how about this,
measure the bore size of the hole, and turn a pin out of copper or "chewy" aluminium. make it just a whisker larger than the hole, tap the pin into the hole and pull the piece straight out?
The copper or soft ally will grip the part but not damage it and worst case scenario you can drill it out easily, but more likely when you pull it out it will stretch some shrinking the diameter a little.
Best Regards
Rick
measure the bore size of the hole, and turn a pin out of copper or "chewy" aluminium. make it just a whisker larger than the hole, tap the pin into the hole and pull the piece straight out?
The copper or soft ally will grip the part but not damage it and worst case scenario you can drill it out easily, but more likely when you pull it out it will stretch some shrinking the diameter a little.
Best Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.