12-30-2023, 05:10 PM
Flycutting is the way to go. RPM slow, medium feed. Small radius on cutter, absolutely sharp. I don't use top rake for CI, but do for aluminum.
Full of ideas, but slow to produce parts
|
Prep For Machining Cast Iron
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Prep For Machining Cast Iron - by EdK - 12-28-2023, 03:00 PM
RE: Prep For Machining Cast Iron - by rleete - 12-28-2023, 03:28 PM
RE: Prep For Machining Cast Iron - by EdK - 12-28-2023, 03:39 PM
RE: Prep For Machining Cast Iron - by Hawkeye - 12-28-2023, 10:50 PM
RE: Prep For Machining Cast Iron - by rleete - 12-29-2023, 12:08 PM
RE: Prep For Machining Cast Iron - by EdK - 12-30-2023, 12:19 AM
RE: Prep For Machining Cast Iron - by rleete - 12-30-2023, 03:19 PM
RE: Prep For Machining Cast Iron - by EdK - 12-30-2023, 04:14 PM
RE: Prep For Machining Cast Iron - by rleete - 12-30-2023, 05:10 PM
|
Users browsing this thread: 1 Guest(s)