12-30-2023, 04:14 PM
(12-30-2023, 03:19 PM)rleete Wrote: Maybe too much play in the ways? New mills have to run in a bit to seat, and then need to be readjusted to eliminate any play.
I don't think that's it. I've got the gibs fairly tight, but it's worth testing with a DI to see if there's any movement.
The fly cutter isn't working too well. I think the geometry of the cutting edge is not quite right so I'm going to put that project aside for now and work on something else until I get the tool ground properly.
Ed