11-30-2023, 01:59 PM
Hello, thanks in advance to any who can help.
In this thread, http://www.metalworkingfun.com/thread-791-page-4.html
I read Stevec 's post regarding tool placement in a shaper clapper, described from a 90 degree position. Can this also be called the tool holder leading or following the clapper?
From your comment, it sounds like setting tool holder behind the clapper head is generally the best practice to prevent the tool digging into the work. Do I have this correct?
Any other general "rule of thumb" to share, I would deeply appreciate.
Ron
In this thread, http://www.metalworkingfun.com/thread-791-page-4.html
I read Stevec 's post regarding tool placement in a shaper clapper, described from a 90 degree position. Can this also be called the tool holder leading or following the clapper?
From your comment, it sounds like setting tool holder behind the clapper head is generally the best practice to prevent the tool digging into the work. Do I have this correct?
Any other general "rule of thumb" to share, I would deeply appreciate.
Ron