Wabeco F1200

[Wongster]

Thanks Dave. Using the bolt down holes is a neat idea! I'll go get some adjustable feet later today. Wabeco mentioned 10mm diameter for the bolt down holes but I measured slightly more than 9mm. M10 bolt can't pass through it so I'll get those feet with M8 threads.

I'm not able to bolt the mill down to the bench top. The bench top is made up of 2 sets of 2 x 15mm plywood with space in between the set (there are some cross pieces to hold them together and to provide support).

The bench top is also not level. The feet would help to level things up.

Any recommendation on the size of vise I should get?

Regards,
Wong