11-28-2023, 05:59 PM
(11-28-2023, 11:48 AM)Vinny Wrote: Any worry about the magnets flying off at high speed?
They'll be super glued in so they should be OK. Right now they're press fit in for testing purposes and it took some effort to get them pressed in so if the testing goes well, I'll run some thin super glue around the edges of the magnets and let them sit overnight. Then I'll put the cover on the gear train and max out the RPMs and see what happens.
Plan B is to 3D print a thin ring that would slip over the magnets as they are now to contain them if necessary. The sensor has a working distance up to 5mm so plenty to work with.
Ed