MetalworkingFun Forum › Machining › General Metalworking Discussion v
Free (Almost) MachTach Machine Tachometer

Thread Modes
Free (Almost) MachTach Machine Tachometer
EdK Offline
Whipping Boy
*******
Posts: 8,859
Threads: 319
Joined: Feb 2012
Location: Arizona/Minnesota
The following 1 user Likes EdK's post:
Highpower (10-29-2023)
#5
10-29-2023, 05:19 PM
Another one ready to go. I had to modify the board a bit because the encoder that this board uses is not available anymore so I had to use a different one that fit the footprint on the PCB.
This one is not as deep but it's obviously taller.

Ed

         
Reply
Thanks given by:


Messages In This Thread
RE: Free (Almost) MachTach Machine Tachometer - by EdK - 10-29-2023, 05:19 PM



Users browsing this thread: 1 Guest(s)