MetalworkingFun Forum › Machining › General Shop Stuff v
Workshop Organization

Thread Modes
Workshop Organization
rleete Offline
Senior
*****
Posts: 771
Threads: 48
Joined: Mar 2012
Location: Rochester, NY
The following 3 users Like rleete's post:
EdK (09-10-2023), Highpower (09-10-2023), f350ca (09-11-2023)
#15
09-10-2023, 05:32 PM
Working on some simple stuff, and I needed to drill and tap #6-32 holes in 15 pieces.  First use of the mill stop, and why I got it done in the first place.  

   
Full of ideas, but slow to produce parts
Reply
Thanks given by:


Messages In This Thread
Workshop Organization - by rleete - 01-30-2022, 10:39 AM
RE: Workshop Organization - by Highpower - 01-30-2022, 11:56 AM
RE: Workshop Organization - by Vinny - 01-30-2022, 02:14 PM
RE: Workshop Organization - by rleete - 02-12-2022, 04:01 PM
RE: Workshop Organization - by Highpower - 02-12-2022, 05:05 PM
RE: Workshop Organization - by Vinny - 02-12-2022, 10:06 PM
RE: Workshop Organization - by Dr Stan - 02-13-2022, 09:38 AM
RE: Workshop Organization - by Highpower - 02-13-2022, 12:37 PM
RE: Workshop Organization - by Vinny - 02-13-2022, 11:44 PM
RE: Workshop Organization - by Mayhem - 02-14-2022, 08:59 PM
RE: Workshop Organization - by JScott - 02-15-2022, 06:54 PM
RE: Workshop Organization - by Vinny - 02-15-2022, 11:28 PM
RE: Workshop Organization - by Highpower - 02-16-2022, 05:54 AM
RE: Workshop Organization - by JScott - 02-16-2022, 08:19 PM
RE: Workshop Organization - by rleete - 09-10-2023, 05:32 PM
RE: Workshop Organization - by rleete - 09-10-2023, 06:52 PM
RE: Workshop Organization - by Vinny - 09-11-2023, 04:28 PM
RE: Workshop Organization - by rleete - 09-11-2023, 06:01 PM
RE: Workshop Organization - by Highpower - 09-11-2023, 07:02 PM



Users browsing this thread: 2 Guest(s)