Sheet Metal tools, Show me your Guillotines

[ETC57]

Rick,

Thanks for the tour, and the education!

Don't apologies for doing your home work and sharing your rewards,

when I get to see others good fortune and success it just reminds me that if I chose I can to!

Thanks for sharing!!!

Jerry.

P.S. Rick you mentioned in your post a Chines 3 in 1 sheer, brake, rolls
was it worth what they sell for? I have often looked at them but thought they might be a little light for the task. As for my metal break it's a sharp edge on a steel table some clamps and a angle iron and hammer.

For rounded corners the back corner of a pickup box and a dead blow hammer has worked so far.