08-12-2023, 12:30 PM
(08-12-2023, 11:16 AM)rleete Wrote: I see your point about the magnets, but as I cut mostly aluminum, it's not as big an issue for me.
Not sure if the thread is large enough, but maybe you could thread in a thin bushing, which is smooth on the inside, but has a groove. Then you could use one of those pins with the ball detent to snap in. That way, you preserve the threads.
Heck, I'm sure you could design a pin that snaps into a bushing, and both parts could be printed. Hmm...
Interesting thought.
Ed