|
Standard for spindle nose thread
|
07-08-2012, 08:57 AM
Yes. They start the flame cut in the slug (off centre) and then move it to the edge before making the final cut. I will probably run a bead to close it up but I doubt it would really make much difference to the end result. Although, I could be wrong.
Hunting American dentists since 2015.
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Standard for spindle nose thread - by Mayhem - 07-08-2012, 02:34 AM
RE: Standard for spindle nose thread - by Highpower - 07-08-2012, 07:43 AM
RE: Standard for spindle nose thread - by DaveH - 07-08-2012, 07:47 AM
RE: Standard for spindle nose thread - by Mayhem - 07-08-2012, 08:57 AM
RE: Standard for spindle nose thread - by TomG - 07-08-2012, 09:31 AM
RE: Standard for spindle nose thread - by Mayhem - 07-08-2012, 09:48 AM
RE: Standard for spindle nose thread - by TomG - 07-08-2012, 04:46 PM
RE: Standard for spindle nose thread - by dallen - 07-08-2012, 05:07 PM
RE: Standard for spindle nose thread - by TomG - 07-08-2012, 06:58 PM
RE: Standard for spindle nose thread - by Mayhem - 07-09-2012, 04:58 AM
RE: Standard for spindle nose thread - by Tony Wells - 07-09-2012, 07:04 AM
RE: Standard for spindle nose thread - by Mayhem - 07-09-2012, 08:05 AM
|
