|
Standard for spindle nose thread
|
 (07-08-2012, 02:34 AM)Mayhem Wrote: I managed to pick up a slug that had been flame cut from a 4" section of pate. For facing, I eyeballed it in the 4 jaw but for turning, I will need to be very close as there isn't much material to play with, diametrically speaking. I'm confused (as usual). Is that piece slit down the side?  Willie
Willie
|
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Standard for spindle nose thread - by Mayhem - 07-08-2012, 02:34 AM
RE: Standard for spindle nose thread - by Highpower - 07-08-2012, 07:43 AM
RE: Standard for spindle nose thread - by DaveH - 07-08-2012, 07:47 AM
RE: Standard for spindle nose thread - by Mayhem - 07-08-2012, 08:57 AM
RE: Standard for spindle nose thread - by TomG - 07-08-2012, 09:31 AM
RE: Standard for spindle nose thread - by Mayhem - 07-08-2012, 09:48 AM
RE: Standard for spindle nose thread - by TomG - 07-08-2012, 04:46 PM
RE: Standard for spindle nose thread - by dallen - 07-08-2012, 05:07 PM
RE: Standard for spindle nose thread - by TomG - 07-08-2012, 06:58 PM
RE: Standard for spindle nose thread - by Mayhem - 07-09-2012, 04:58 AM
RE: Standard for spindle nose thread - by Tony Wells - 07-09-2012, 07:04 AM
RE: Standard for spindle nose thread - by Mayhem - 07-09-2012, 08:05 AM
|
