Mini-Lathe Bearing Puller

[EdK]

(06-08-2023, 08:05 AM)Highpower Wrote:
Remember - that puller kit was designed to remove and install the factory standard size deep groove ball bearings. If you are installing tapered roller bearings or the angular contact type ball bearings you have to compensate for the race differences on your own I'm afraid. But you managed that like a boss!  

I never press fit bearings dry. Always use a bit of light lubrication.

I didn't even have to pound it on. I used the tube and the very long bolt with a nut and squeezed it on.

Ed