As I haven't been down in the shop for a while, I figured I'd start with something simple, and knock one off the list.
A simple home-made dead blow hammer. Faces are polypropylene and Delrin. Handle is ash with Danish oil finish. Fitting is a 3/4 pipe thread in brass.
Lead shot - #7, I think - is inside. It has 3.7 oz., which is about all it would hold and still leave space to move.
Handle is JB welded and pinned into handle. Faces are threaded in; made with a cheap die I bought on a whim.
A simple home-made dead blow hammer. Faces are polypropylene and Delrin. Handle is ash with Danish oil finish. Fitting is a 3/4 pipe thread in brass.
Lead shot - #7, I think - is inside. It has 3.7 oz., which is about all it would hold and still leave space to move.
Handle is JB welded and pinned into handle. Faces are threaded in; made with a cheap die I bought on a whim.
Full of ideas, but slow to produce parts