|
X Power Feed
|
|
05-26-2023, 05:50 PM
I finally got around to trying it on the mill. Lots of torque, couldn't even slow it down by pushing against the table. Way too slow for a rapid traverse though. I think I'll look for a motor that's 200 - 250 RPMs. The one I have now will work for raising and lowering the head so it wasn't a wasted purchase.
Ed |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
X Power Feed - by EdK - 05-08-2023, 03:28 PM
RE: X Power Feed - by EdK - 05-13-2023, 02:16 PM
RE: X Power Feed - by EdK - 05-20-2023, 10:55 AM
RE: X Power Feed - by EdK - 05-21-2023, 11:36 PM
RE: X Power Feed - by EdK - 05-22-2023, 06:10 PM
RE: X Power Feed - by EdK - 05-26-2023, 05:50 PM
RE: X Power Feed - by EdK - 05-30-2023, 11:14 PM
RE: X Power Feed - by Highpower - 05-31-2023, 03:03 AM
RE: X Power Feed - by EdK - 06-03-2023, 12:49 AM
RE: X Power Feed - by EdK - 12-18-2023, 02:58 PM
RE: X Power Feed - by Highpower - 12-18-2023, 05:03 PM
RE: X Power Feed - by EdK - 12-18-2023, 07:44 PM
RE: X Power Feed - by rleete - 03-22-2024, 06:18 AM
RE: X Power Feed - by EdK - 03-22-2024, 11:33 AM
RE: X Power Feed - by rleete - 03-23-2024, 08:48 AM
RE: Todays Project - What did you do today? - by EdK - 05-11-2023, 08:02 PM
RE: Todays Project - What did you do today? - by Highpower - 05-11-2023, 09:26 PM
RE: Todays Project - What did you do today? - by Vinny - 05-11-2023, 09:34 PM
RE: Todays Project - What did you do today? - by EdK - 05-11-2023, 09:48 PM
RE: Todays Project - What did you do today? - by Highpower - 05-11-2023, 09:49 PM
RE: Todays Project - What did you do today? - by EdK - 05-11-2023, 10:55 PM
RE: Todays Project - What did you do today? - by EdK - 05-12-2023, 06:10 PM
X Power Feed - by EdK - 05-13-2023, 02:07 PM
|
