05-17-2023, 03:57 PM
I've been wanting some broaches for a long time, and I finally bit the bullet and got some. Seller is discount_machine, on eBay. It pictured a plain wooden box, but the one that showed up is this fancy case as shown:
Inside is nice, too:
And after just a few minutes with the arbor press, this is the result:
Cutters are very sharp, and all the parts appear very well made. 1/2" bushing was a nice slip fit in the 1/2" bore of the part. Since the bushing and shim are both shorter than the part, I ran it through from both ends. I am pleased with this purchase, and wish I had gotten it years ago.
Inside is nice, too:
And after just a few minutes with the arbor press, this is the result:
Cutters are very sharp, and all the parts appear very well made. 1/2" bushing was a nice slip fit in the 1/2" bore of the part. Since the bushing and shim are both shorter than the part, I ran it through from both ends. I am pleased with this purchase, and wish I had gotten it years ago.
Full of ideas, but slow to produce parts