engine No10

[krv3000]

hi no problem when you get a compact 8 from new their is no face plate Wat you get is a drive pin that goes in to one of the fixing holes for the chuck and you use that to drive a lathe dog well i don't have any lathe dog's their on me too do list with a drive pin so to drive the con rod that's the bit bin made i made a post out of sum scrap ally drilled the bottom and tap it m8 and fitted a m8 stud then on top of that i made up a u shape to be a snug fit over the bottom end of the con rod. that was fit ed to the top of the post by a m6 cap Heda if i still have it i will get a pic of it for you but her is sum pics of the crank bin machined up in the same way