ER40 - How Thin?
#8
For just facing thin material I've had luck with facing off the end of a piece of bar stock in the chuck and super gluing the thin part to the end of it. Just take light cuts. A little heat or Acetone will remove the super glue afterward. Or use double stick (carpet) tape. If I needed to do a bunch of parts though, I would go with the collet fixture. Smiley-gen163
Willie
Reply
Thanks given by:


Messages In This Thread
ER40 - How Thin? - by Vinny - 02-06-2023, 01:31 PM
RE: ER40 - How Thin? - by EdK - 02-06-2023, 10:24 PM
RE: ER40 - How Thin? - by Vinny - 02-06-2023, 11:46 PM
RE: ER40 - How Thin? - by Dr Stan - 02-07-2023, 11:18 AM
RE: ER40 - How Thin? - by Highpower - 02-07-2023, 11:45 AM
RE: ER40 - How Thin? - by Vinny - 02-07-2023, 11:59 AM
RE: ER40 - How Thin? - by EdK - 02-07-2023, 02:38 PM
RE: ER40 - How Thin? - by Highpower - 02-07-2023, 08:33 PM
RE: ER40 - How Thin? - by Vinny - 02-08-2023, 10:30 AM
RE: ER40 - How Thin? - by Dr Stan - 02-09-2023, 11:02 PM
RE: ER40 - How Thin? - by Vinny - 02-10-2023, 11:59 AM
RE: ER40 - How Thin? - by Vinny - 02-16-2023, 04:10 PM



Users browsing this thread: 2 Guest(s)