01-11-2023, 08:00 AM
(This post was last modified: 01-11-2023, 08:00 AM by Lockwood1956.)
So I decided I would try to manufacture a shaft (temporarily) to see if i was right.
So using my mill and lathe (set back up in original configuration, I made a shaft, with a sleeve on it that would hold the gear and spin to test if i was right?
Here it is in the picture below. I amazed myself that i managed the job, :)
So using my mill and lathe (set back up in original configuration, I made a shaft, with a sleeve on it that would hold the gear and spin to test if i was right?
Here it is in the picture below. I amazed myself that i managed the job, :)
Churchill Cub Lathe Mk3a, Dore Westbury Mk1 Mill
Recently retired, new to machining and having loads of fun
Recently retired, new to machining and having loads of fun